Skip to content


Carving Sprue Plants

I was asked to write a “how-to” on making plants out of sprues.

“What are sprues?”, you ask.

Sprues are the plastic frames that multipart models or minis come on. Most people cut the pieces off and throw out the frame. Not me. I never throw anything out (much to my wife’s displeasure).

I wasn’t going to write this up because it’s insanely easy and fast.

Let’s start with the finished product:

 

sprueplantsfinalI have to warn people though, you will be cutting TOWARDS yourself with a VERY SHARP KNIFE! You will cut yourself eventually. Don’t say I didn’t warn you. This will also be a very short write up as I’ll let the pictures do most of the talking (sorry, a couple are fuzzy).

 

sprue_how_to1

The list of materials is: Sprues!
The tools are: Hobby Knife and Side Cutters (bandaids)

 

sprue_how_to2 sprue_how_to3

The thing to understand is that the greater the angle of the knife, the deeper the cut and the thicker the “leaf”. The closer the blade is to lying flat against the sprue, the thinner and curlier the “leaf” will be.

 

sprue_how_to4

Our doner sprue. You need it to be long enough for you to hold onto. Too short and it’s impossible to work with. Lots of wastage but who cares, leftovers can be used as sprue rubble.

 

sprue_how_to5

I start by making cuts around the sprue at the same level. I always start on the corner edges.

 

sprue_how_to6

I move down the sprue and do it again

 

sprue_how_to7

I go back up to the first level and cut the leaves deeper to overlap the lower row.

sprue_how_to8

Do this until you are happy with it. I twisted off the center stub but you can just cut it off.

 

sprue_how_to9

Top down view.

 

sprue_how_to10

Cut it to size, make sure the flat side is to the plant.

 

sprue_how_to11

Tada! One plant.

 

sprue_how_to12

I did exactly the same thing to this plant but kept it at one level and… for added effect, made tiny tiny cuts in each leaf. Careful, the knife goes through these thin bits like they were butter.

 

sprue_how_to13

Lets make a bigger, curlier plant now. Make longer, shallower cuts. This time the first cut makes the bottom level of leaves.

 

sprue_how_to14

Around and around we go.

 

sprue_how_to15

Make as many levels as you can and cut off the center stalk (or not).

 

sprue_how_to16

That’s it. The three plants I showed you and then a mushroom that I carved. If you are really really really bored, you can cut out individual leaves (the two little bits on the right) and use them as needed. And No. I don’t plan on doing a basing and painting tutorial.

sprueplants2 sprueplants1 sprueplants3

Posted in Scratch Building.


One Response

Stay in touch with the conversation, subscribe to the RSS feed for comments on this post.

  1. Rob says

    This is a reprint of the original Dungeon Crawlers article. All Terrain articles will eventually be moved here.

You must be logged in to post a comment.